- New operator property to toggle edge panning in the keymap:
This is disabled by default to avoid edge-panning in cases where it
gets distracting, such as adding a new node. Only the explicit
translate operator(s) (GKEY or drag) have this enabled now.
- Restore the initial view rect on edge pan cancel:
The initial view rect is now stored in the edge pan operator data.
When an operator with edge panning is cancelled it can now call the
`UI_view2d_edge_pan_cancel` function to restore the original View2D
rect.
- Less delay in node editor scrolling:
Delay is useful when scrolling through long lists, such as in the
outliner, but makes node scrolling feel sluggish and unresponsive.
The lower scroll speed here makes a faster response the better option.
- Zoom influence feature:
Somewhat slower scrolling in UI-space when zoomed out. With the 0.5
zoom influence factor nodes behave as if zoom factor is halved,
otherwise it gets too fast when zoomed out. Previously scrolling would
always be constant-speed in UI space, now it's half-way between UI
space and node (view) space.
Starts scrolling when dragging a node or node link and going outside the current window.
Largely copied from the VIEW2D_OT_edge_pan operator.
Edge panning operator customdata and supporting functions now in
UI_view2d.h, so they could be used by operators in other editor
libraries. The VIEW2D_OT_edge_pan operator also uses this customdata and
shared functions now. Operators properties can be used to configure
edge panning margins and speed for each use case, rather than using
hardcoded values.
The speed function for edge panning has been tweaked somewhat:
* "Speed per pixel" has been replaced with a "speed ramp" distance.
This is more intuitive and also creates an upper bound for the speed,
which can otherwise become extreme with large cursor distance.
* "Max speed" is reached at the end of the speed ramp.
* Padding the region inside and outside is applied as before, but both
values are operator properties now.
Node transform operator also supports edge panning. This requires
an offset for changes in the view2d rect, otherwise nodes are "stuck"
to the original view.
Transform operator had cursor wrapping categorically enabled, but this
gets quite confusing with the edge scrolling mechanism. A new TransInfo
option T_NO_CURSOR_WRAP has been introduced to disable this behavior.
The double negative is a bit annoying, but want to avoid affecting the
existing transform modes, so by default it should still set the
OP_IS_MODAL_GRAB_CURSOR flag (which then sets the WM_CURSOR_WRAP_XY
flag during modal execution).
Reviewed By: HooglyBoogly, JacquesLucke
Differential Revision: https://developer.blender.org/D11073
