Knife projection tool doesn't work when similar cuts are performed #41991

New Issue

Bastien Montagne · 2014-09-28T20:04:09+02:00

wesgilster commented

2014-09-28 20:04:09 +02:00

(Migrated from localhost:3001)

System Information
HP Pavilion Laptop

Blender Version
Broken: 2.7.1
Worked: Don't know If it ever did

Short description of error
The knife project tool doesn't cut a target face properly when the knife face previously cut through the target face on a prior knife projection operation that was performed on a similar axis.

Exact steps for others to reproduce the error
Go into edit mode, perform the knife project, with the cut through option turned on. Notice that the second target face was cut fine, but the first target face failed to cut properly. Translating the knife face up or down will make it work properly, or precutting the failing face with a single knife cut will allow this to work.

JustClickTheKnifeProjectToolOnTheSelectedFaces.blend

**System Information** HP Pavilion Laptop **Blender Version** Broken: 2.7.1 Worked: Don't know If it ever did **Short description of error** The knife project tool doesn't cut a target face properly when the knife face previously cut through the target face on a prior knife projection operation that was performed on a similar axis. **Exact steps for others to reproduce the error** Go into edit mode, perform the knife project, with the cut through option turned on. Notice that the second target face was cut fine, but the first target face failed to cut properly. Translating the knife face up or down will make it work properly, or precutting the failing face with a single knife cut will allow this to work. [JustClickTheKnifeProjectToolOnTheSelectedFaces.blend](https://archive.blender.org/developer/F113434/JustClickTheKnifeProjectToolOnTheSelectedFaces.blend)

wesgilster commented

2014-09-28 20:04:09 +02:00

(Migrated from localhost:3001)

Changed status to: 'Open'

wesgilster commented

2014-09-28 20:04:09 +02:00

(Migrated from localhost:3001)

Added subscriber: @wesgilster