Unknown engine warning only shown when loading from a popup #109952
Loading a blend file from the command line or an open-file window fail to display the report that an unsupported engine was found.
This can be redone by saving a blend file with the CYCLES engine enabled, then disabling cycles and reloading file.
To simplify testing this a blend file has been attached.
Open the file from the popup file selector.
Note that the status area has no message.
Now re-open the same file from a popup (Ctrl-O, and re-open this file).
A warning is now displayed that the engine in this file is not supported.
The same issue occurs when loading this file from the command-line.
7e24a0a2ecd7b580e9c9911902d70340fd48d379 and 3.6 LTS.
No due date set.
No dependencies set.
Deleting a branch is permanent. Although the deleted branch may continue to exist for a short time before it actually gets removed, it CANNOT be undone in most cases. Continue?